Mixing Polycharger with Waxes
When mixing waxes, fill a mixing bottle to the desired level (1, 2 or 3 ounce mark) and add the proper dosing of Polycharger. Cap the mixing bottle and shake for 30 to 45 seconds. Your boosted wax is ready to apply. Cap your bottle of Polycharger immediately or it will spoil (harden).Be sure to use a clean mixing bottle with each wax mixture. Additional mixing bottles can be purchased from a local drug store or where ever Polycharger is sold. If you are mixing an additional batch on the same day, it is okay to reuse the mixing bottle. Apply Polycharger boosted wax per the wax manufacturer's instructions.
Mixing Polycharger with Sprays
When mixing sprays, remove the sprayer and add the proper dosing of Polycharger. There are no shelf life concerns with boosting detailing sprays, so Polycharger can be added directly to the original product bottle. Put the cap back on the spray bottle and shake well. Shake again before each use.Safety First And Foremost
As with all chemicals, keep out of the reach of young children. If ingested, do not induce vomiting and dilute with a glass of milk. Consult medical attention immediately for hydrocarbon poisoning. If Polycharger comes in contact with your eyes, flush immediately with fresh water for ten minutes or until irritation discontinues. Wash from skin with soap and water.
Polycharger Dosing
When mixed with a liquid wax, Polycharger acts as a polymer curing accelerant. Do not mix more wax than you plan to use in 48 hours. After two days a boosted wax mixture must be thrown away, as the wax will thicken or harden in the bottle.Your Polycharger kit comes with three mixing bottles and a 60 ml bottle of Polycharger additive. This is enough additive to boost 24 to 30 ounces of wax (depending on the brand) or two gallons of detailing spray. The average car requires about two ounces of wax for a complete coating and one to two ounces of spray for maintenance. To avoid waste, we suggest boosting no more than three ounces of wax at one time.
Dosing (measuring) Polycharger is very easy. The bottle of Polycharger additive includes a glass dropper with a rubber squeeze bulb. Each full depression and release of the rubber bulb loads 50% of the glass dropper. This is "one dose" of Polycharger additive. Most liquid wax products require two doses of Polycharger additive per ounce. Correct dosing information is provided in the Compatibility and Dosing Chart below.
NOTE: Shake Polycharger well before dosing. If Polycharger is not shaken, dosing will not be correct and the desired results will not be achieved.